I picked up a 93 storm 750.
I took carbs apart and cleaned them, they were nasty and full of crystals. I put then back together and it ran good except for when u take off right when the clutch starts to engage there is about a 500 rpm spot where it just didn't seem to have power, but didn't fall on its face.
So I went to look at the jet needle, and found that the clip was on the very top, which I know was wrong, so I put it back on the center clip.
The lack of power is gone, all seemed fine, but after about 30 min of riding the plugs would foul out.
I take the jet needles out and all of them is slightly bent, not sure if that would cause it to foul the plugs out fast.
I do not know what main jets r in there because I cannot read the #'s off of them.
What I want to do is just go back to stock carb settings.
The sticker on the hood says pto 320, center cyclinder 320, and 340.
It says the jet needle is 6cey6, and that is the same as I can read off the needles.
And stock pilot jets are 35.
I can find the main jets and pilot jets but am having a hard time finding the needles, does anyone know where I can get the needles from?
As would the bent needles cause this problem or is it more likely it was jetted for up north and needs to be back to stock.
Thanks in advance
I took carbs apart and cleaned them, they were nasty and full of crystals. I put then back together and it ran good except for when u take off right when the clutch starts to engage there is about a 500 rpm spot where it just didn't seem to have power, but didn't fall on its face.
So I went to look at the jet needle, and found that the clip was on the very top, which I know was wrong, so I put it back on the center clip.
The lack of power is gone, all seemed fine, but after about 30 min of riding the plugs would foul out.
I take the jet needles out and all of them is slightly bent, not sure if that would cause it to foul the plugs out fast.
I do not know what main jets r in there because I cannot read the #'s off of them.
What I want to do is just go back to stock carb settings.
The sticker on the hood says pto 320, center cyclinder 320, and 340.
It says the jet needle is 6cey6, and that is the same as I can read off the needles.
And stock pilot jets are 35.
I can find the main jets and pilot jets but am having a hard time finding the needles, does anyone know where I can get the needles from?
As would the bent needles cause this problem or is it more likely it was jetted for up north and needs to be back to stock.
Thanks in advance
93 storm 750 carb ?'s
0 commentaires:
Enregistrer un commentaire